Casella-cel CEL-440 Manuel d'utilisateur télécharger pdf (Page 3)

Warnings !

LOAD BATTERIES following the instructions given in

Section 1.3. Make sure they are inserted in the orientations

shown inside the battery compartment .

A single cell installed with the wrong polarity may still allow

the instrument to function, but will cause overheating

severe enough to rupture a cell, with consequent risk to the

operator and damage to the instrument.

DO NOT REMOVE the protective grid from Type 1

microphone capsules as this will expose the diaphragm,

which is extremely vulnerable to damage.

UNDER NO CIRCUMSTANCES should these instruments be

cleaned using a solvent based cleaner.

Repairs of damage caused by a failure to observe these

warnings will NOT be covered by the normal warranty

conditions.

Notes !

The CEL-440 and CEL-480 are supplied complete with Type 1 or Type 2

Electret Microphones and have no need of a 200 V polarizing supply.

Therefore no such supply is available and it is safe to ignore the 200 V

polarising supply warnings shown on CEL-250 or MK 250 microphone

packaging.

Throughout this book, display screens that are available only on a

CEL-480 will be shown with a dashed - - - - outline.

Contents

1 2 3 4 5 6 7 8 ... 69 70

Pas de commentaire

Casella-cel CEL-440 Manuel d'utilisateur Page 3